You can also do this a different way by purchasing a USB-C to RJ45 Ethernet ( LAN) adapter cable (ideally with Android v11 installed), which might work better if you’re using a device that doesn’t have a USB-C port or support tethering via USB (we didn’t try this ourselves). NOTE: All speed testing results were recorded on the laptop.ĭAY 1 – Baseline Speeds via WiFi TetheringĭAY 2 – Baseline Speeds via WiFi TetheringĪt this point we switched off the OnePlus’s WiFi Hotspot and connected a USB-C to USB-C cable made by Nimaso. Signal strength via 4G was very good, although in this location we were only able to connect via Band 1 (2100MHz). Prior to this we also conducted an additional 30 tests (each day) in order to try and establish a reasonable baseline of performance using the WiFi Hotspot. We repeated this all again on day two, albeit between 1pm and 2pm. We opted to use Ookla’s service for the testing (picking the same remote server each time) and have displayed the resultant speeds as a typical range below (intended to reflect the inherently wide variations of mobile performance).Īpproximately 50 tests were conducted over a two hour period on day one, including 25 via a WiFi Hotspot and 25 via USB, which occurred between 10am and 11am. We also continued to run these tests in-between our wired benchmarks, which helped to confirm that the mobile network, speed and signal quality were all still operating close to the established baseline.Īll of the testing was conducted at the same indoor location and with the devices positioned directly next to one another. We also picked Three UK for the test as in this area they appeared to deliver the most consistent performance, but such things will vary from place to place.īefore getting started we ran multiple tests using WiFi in order to try and establish what the rough baseline performance expectation should be for a normal WiFi based Tethering experience. As for the Smartphone, we used a OnePlus 7T Pro running Android v10. Conducting the USB-C Tethering Testįor the purpose of this test we made use of a Microsoft Surface Pro 7 computer (a tablet / laptop hybrid).
USING USB JOTSPOT ON WINDOWS 7 UPDATE
However, this should improve further with Android v11, which allows such devices to serve as the host network as well – ‘ Ethernet tethering‘ (we don’t have the v11 update yet and so haven’t been able to test this). We should add that Android devices have supported connectivity via wired networks for years (particularly since v6 “ Marshmallow” in 2015), but experiences do tend to vary between different Smartphones.